1 svenska recension skriven för Extrudr PLA NX2 Matt Light blue
3 kundrecensioner i alla språk
4,4 av 5 stjärnor
| 5 stjärnor | | 6 | (60%) |
|---|---|---|---|
| 4 stjärnor | | 3 | (30%) |
| 3 stjärnor | | 0 | (0%) |
| 2 stjärnor | | 1 | (10%) |
| 1 Stjärnor | | 0 | (0%) |
Filtrera recensioner:
-
Var den här recensionen till hjälp för dig? (2) (0)
Senaste artiklarna:
Upptäck 3DJake:
-
Sverige: Fri standardfrakt från 1 099 kr
-
Gratis
returer Mer än 10.400 produkter
Vi levererar över hela världen till över 40 länder
Betygsatt med 4 från 5 stjärnor.
Good but not good as they say
There are some problem with this filament but i think it's depend on what type of bed you use. I have a glas bed with coating and i had major problem getting this to stick from 0-60 celsius. But when I raised the temp from 60 to 70 then it was hard to remove. So i lowered the temp to 65 and that seems to work very well. Maybe the temp sensor is not correct on my machine...but if you experience sticking problem then try to raise the temp a bit... Don't use raft on this...it will not stick together properly with the object. I have not tried brim but i don't think you will need it if you try 65-70 celsius. It's very hard to remove at 70. You will also have to test different fan speed and retraction to get this work good. Best is to google for that answer